WIPE NEW Trim Restorer Kit - WIPE 1 - Restore Faded Plastics To New
WIPE NEW - WIPE 1 - Trim Restorer Kit
Apply once for lasting protection, even after hundreds of car washes Restores and protects from oxidation, fading and sun damageProvides UV Protection
No Silicone, No Oils, No Mess
Use on dashboards, door panels, leather and vinyl seats and trim
Also use on plastic and rubber bumpers, trim, mirror housings, roof racks, grilles, cowls and more
Non-greasy, no-slip formula is safe to use on steering wheels, running boards and more
Enough for the interior or exterior of an average mid-sized vehicle
Saves you both time and money
FOR BEST RESULTS:
Use in well ventilated and covered areas away from the sun.
Do NOT apply Wipe New to hot surfaces or in direct sunlight.
Ensure surface is clean, dry and cool to ambient temperature before applying Wipe New.
SURFACE PREPARATION:
Wash the intended surface thoroughly with a standard soap, cleaner or car wash (free of wax, moisturizers or other additives).
Rinse and let dry.
For best results, apply a degreaser to heavily worn areas to fully clean the surface. It is important that no water remains on the surface. Gently tap the intended surfaces. If water is present, the tapping will make the water run. Clean with a dry rag. Open all car doors and trunk to ensure all excess water is found.
APPLICATION:
Make sure surface is completely dry before application. When applying Wipe New Trim Restore, wear the included nitrile gloves and always use in a well ventilated area. If applying on a vehicle interior, roll the windows down before beginning. Plan to work from the highest point of your vehicle down to the lowest. This helps to keep freshly coated surfaces from being touched before they are dry.Test Wipe New Trim Restore on an inconspicuous area before application to ensure the result is desirable. Results will vary by material and surface damage. Wearing the included gloves, open a Wipe-It packet. Apply in a single wipe to the intended surface with little or no overlap, from one row to the next, until the surface is completely coated. If Trim Restore begins to dry on the Wipe-It, streaking may occur. Once the Wipe-It dries out completely, or becomes contaminated, it cannot be reused and must be discarded. Open one of the additional Wipe-Its provided and continue.
TIP: Fold the Wipe-It cloth in half and then into a quarter. If a portion of the cloth becomes soiled then flip to a clean portion of the cloth. Repeat throughout the application.
NOTE: For badly faded and/or extremely porous surfaces, a 2nd coat may be required for optimal results. If applicable, allow the first coat to dry for a minimum of 5, up to a maximum of 10, minutes then immediately repeat previous step If Wipe New comes in contact with an unintended surface such as paint; wipe it off immediately with a dry cloth. Within an hour of application (while still undergoing initial cure), acetone may be used to remove Wipe New from a painted surface, but not from plastic or any nonmetal surface. Because acetone can damage vehicle parts or paint, it should be used only after checking with the vehicle manufacturer or a Certified Paint Professional as to how to best apply or remove product. After Wipe New has cured, removing it will require the use of a fine polishing compound or high grit automotive sandpaper.
DRY TIME: Let Wipe New dry for 1 hour in a dry, well-ventilated area before touching the treated surface. Allow 24 hours after application before exposing treated surface to moisture (rain, dew, sprinklers, car wash, etc). Store excess product in a cool, dry place.
COVERAGE: Coverage may vary depending on material, wear and size of vehicle. One kit will treat the interior or exterior of an average, mid-sized car.
DISPOSAL: When finished, set the applicator cloth in a location out of the reach of children and allow it to dry completely prior to discarding (a few hours).
Made in USA
